Our CurrentBody Skin LED Light Therapy products are FDA-cleared as safe and effective at-home beauty devices. Cleared in 2019 by the FDA, our mask is especially one of the only LED masks cleared for the treatment of wrinkles in the world.

CONTRAINDICATIONS

DO NOT use this device to treat any other conditions apart from those listed in the indications for use. This device has not been tested for any other conditions than those listed, and the risk is unknown.

DO NOT use this device if you are pregnant, planning on becoming pregnant or breastfeeding. This device has NOT been tested on pregnant or breast-feeding women and therefore the risk to the foetus, neonate or pregnant women is unknown.

DO NOT use this device if you suffer from Lupus erythematosus, photosensitive eczema or Albinism. If you use this device system to treat Lupus erythematosus, photosensitive eczema or Albinism you may cause a severe skin reaction.

DO NOT use this device if you suffer from any photosensitive disorder (sensitisation to light). If you use this device and you suffer from a photosensitive disorder you may cause a severe skin reaction.

DO NOT use the device if you suffer from light-induced headaches.

DO NOT use the device if you suffer from any genetic conditions of the eye.

DO NOT use this device if you are taking any medication that can cause photosensitivity. If you use this device and you are taking any medication that can cause photosensitivity you may cause a severe skin reaction. Photosensitivity is a common side effect of various medications. These can include certain antibiotics, chemotherapy drugs, and diuretics. If you are unsure about any medication you may be taking consult your healthcare provider. Other substances not listed above can also cause photosensitivity. Common examples of these substances are St John’s Wort, Coal tar, deodorants, antibacterial soaps, artificial sweeteners, naphthalene (moth balls), petroleum products, brightening agents found in laundry detergent, and cadmium sulphide (a chemical injected into the skin during tattooing.

SENSITIVITY TEST

Before carrying out your first treatment you must carry out a sensitivity test. Follow the step by step guide below;

1. Place the device over your inner arm.

2. Switch ON the controller and allow the device to run for its full 10-minute treatment program. The device will automatically switch off after 10 minutes.

3. At any time if your skin feels HOT or uncomfortable STOP using the device immediately.

4. After the treatment wait at least 6 hours. If the skin on your inner arm appears red and/or itchy the device is unsuitable for you.